Comparison With Other Vacuums.
It’s important to clean it to prevent bad odours or bacterial growth.. To clean the canister, fully detach it from the vacuum, empty it, then use a dry microfibre cloth to remove any loose dirt.Wash the canister in water with washing up liquid, before thoroughly rinsing it with cold water.. As always, make sure the bin is completely dry before you reattach it!.
This step is much easier if you have a bagged vacuum, as you’ll just need to replace the old bag with a new one.It’s still a good idea to wipe down the compartment holding the bag though..Never use a bagged vacuum without a bag, unless the manual says this is fine.
The bag acts as the primary filter in a bagged vacuum.Without it, the pre-motor filter will become clogged much faster, and the motor may be more exposed to dirt..
Step 5: Clean the Vacuum’s Interior and Remove Clogs.
This step can be performed throughout the cleaning process, but it’s easiest when the dust canister is removed and drying..Pull out the filter from inside the housing using the metal handle..
Tap off loose dirt and debris into a bin.. (Optional) Rinse the filter in lukewarm water.You should only handwash the filter and never use any detergents or cleaning products..
If you’ve rinsed it, allow the filter at least 24 hours to dry fully before you reinsert it into the housing..Replace the filter into the housing and slide the housing back onto the vacuum.. Do you have any questions about how to clean the filter on a Shark WV200UK?
(Editor: High-End Luggage)